Show simple item record

dc.contributor.advisorHeal, Mathewen
dc.contributor.advisorMount, Andrewen
dc.contributor.authorWu, Haoen
dc.date.accessioned2018-02-15T11:40:43Z
dc.date.available2018-02-15T11:40:43Z
dc.date.issued2017-11-30
dc.identifier.urihttp://hdl.handle.net/1842/28755
dc.description.abstractOutdoor air pollution is a major contributor to adverse health effects of citizens, in particular those living in urban environments. Air quality monitoring networks are set up to measure air quality in different environments in compliance with national and European legislation. Generally, only a few fixed monitoring sites are located within a city and thus cannot represent air pollutant concentrations in urban areas accurately enough to allow for a detailed human exposure assessment. Other approaches to derive detailed urban air pollutant concentration estimates exist, such as dispersion models and land-use regression (LUR) models. Low-cost portable air quality monitors are also emerging, which have the potential to add value to existing monitoring networks by providing measurements at greater spatial resolution and also to provide individual-level exposure assessment. The aim of this thesis is to demonstrate how measurements and modelling in combination allow detailed investigations of the variability of air pollutants in space and time in urban area, and in turn improve on the current exposure assessment methods. Three types of low-cost portable monitors measuring NO2, O3 (Aeroqual monitors) and PM2.5 (microPEM monitor) were evaluated against their respective reference instruments. The Aeroqual O3 monitor showed very good correlation (r2 > 0.9) with the respective reference instruments, but biases in the slope and intercept coefficients indicated that calibration of Aeroqual O3 monitor was needed. The Aeroqual NO2 monitor was subject to cross-sensitivity from O3, which, as demonstrated, can be effectively corrected by making O3 and NO2 measurements in tandem. Correlation between the microPEM monitor and its reference instrument was poor (r2 < 0.1) when PM2.5 concentrations were low (< 10 μg m-3), but significantly improved (r2 > 0.69) during periods with elevated PM2.5 concentrations. Relative humidity was not found to affect the raw results of PM2.5 measurements in a consistent manner. All three types of monitors cannot be used as equivalent or indicative methods instead of reference methods in studies that require quantification of absolute pollutant concentrations. However, the generally good correlations with reference instruments reassure their application in studies of relative trends of air pollution. Concentrations of PM2.5, ultrafine particles (UFP) and black carbon (BC) were quantified using portable monitors through a combination of mobile and static measurements in the city of Edinburgh, UK. The spatial variability of UFP and BC was large, of similar magnitude and about 3 times higher than the spatial variability of PM2.5. Elevated concentrations of UFP and BC were observed along streets with high traffic volumes whereas PM2.5 showed less variation between streets and a footpath without road traffic. Both BC and UFP significantly correlated with traffic counts, while no significant correlation between PM2.5 and traffic counts was observed. The relationships between UFP, NO2 and inorganic components of PM2.5 were further investigated through long-term measurements at roadside, urban background and rural sites. UFP moderately correlated with NOx (NO2 + NO) and showed varying relationships with NOx depending on the particle size distribution. Principal component analysis and air-mass back trajectory analysis revealed that PM2.5 concentrations were dominated by long-range transport of secondary inorganic aerosols, whereas UFP were mainly related to varying local emissions and meteorological conditions. These findings imply the need for different policies for managing human exposure to these different particle components: control of much BC and UFP appears to be manageable at local scale by restricting traffic emissions; however, abatement of PM2.5 requires a more strategic approach, in cooperation with other regions and countries on emissions control to curb long-range transport of PM2.5 precursors. A dispersion model (ADMS-Urban) was used to simulate high resolution NO2 and O3 concentrations in Edinburgh. The effects of different emission and meteorological input datasets on the resulting modelled NO2 concentrations were investigated. The modelled NO2 and O3 concentrations using the optimal model setup were validated against reference instrument and diffusion tube measurements. Temporal variability of NO2 was predicted well at locations that were not heavily influenced by local effects, such as road junctions and bus stops. Temporal variability of O3 was predicted better than for NO2. Long-term spatial variability of NO2 was found to correlate well with diffusion tube measurements, while modelled spatial variability of O3 in ADMS-Urban compared poorly with diffusion tube measurements. However, it was found that the O3 diffusion tube measurements may be subject to some unidentified biases affecting their accuracy. Land-use regression (LUR) models are widely used to estimate exposure to air pollution in urban areas. An appropriately sized and designed monitoring network is an important component for the development of a robust LUR model. Concentrations of NO2 were simulated by ADMS-Urban at ‘virtual’ monitoring sites in 54 different network designs of varying numbers and types of site, using a 25 km2 area including much of the Edinburgh city area. Separate LUR models were developed for each network. These LUR models were then used to estimate ambient NO2 concentrations at all residential addresses, which were evaluated against the ADMS-Urban modelled concentration at these addresses. The improvement in predictive capability of the LUR models was insignificant above ~30 monitoring sites, although more sites tended to yield more precise LUR models. Monitoring networks containing sites located within highly populated areas better estimated NO2 concentrations across all residential locations. LUR models constructed from networks containing more roadside sites better characterised the high end of residential NO2 concentrations but had increased errors when considering the whole range of concentrations. No particular composition of monitoring network resulted in good estimation simultaneously across all residential NO2 concentration and of the highest NO2 levels implying a lack of spatial contrast in LUR-modelled pollution surface compared with the dispersion model. Finally, the results from the measurement and modelling studies presented in thesis are synthesised in the context of current exposure assessment studies. Low-cost air-quality monitors currently do not possess and are unlikely in the near future to provide the robustness and accuracy to replace the existing routine monitoring network. Development of the low-cost air-quality should be aiming at upgrading them as the indicative method as defined in the data quality objective in the EU directive. The monitoring sites used to build LUR models should capture well the population distribution in the study area as opposed to capturing the greatest pollution contrast. The traditional methods of evaluating LUR models are also ineffective in characterising the models’ capability at estimating pollutant concentration at residential address. Given that the dispersion models are also subject to the availability and uncertainties in the input data, future air quality model development should endeavour to incorporate both dispersion and land-use regression models, where the uncertainty in the input data can be reduced by using LUR models built on actual measurements, and the limitation in the statistical modelling can be replaced by adopting the deterministic approach used in the dispersion model.en
dc.language.isoen
dc.publisherThe University of Edinburghen
dc.relation.hasversionWu, H., Reis, S., Lin, C., Beverland, I.J., Heal, M.R., 2015. Identifying drivers for the intra-urban spatial variability of airborne particulate matter components and their interrelationships. Atmos. Environ. 112, 306–316. doi:10.1016/j.atmosenv.2015.04.059en
dc.relation.hasversionWu, H., Reis, S., Lin, C., Heal, M.R., 2017. Effect of monitoring network design on land use regression models for estimating residential NO2 concentration. Atmos. Environ. 149, 24–33. doi:10.1016/j.atmosenv.2016.11.014.en
dc.relation.hasversionKenagy, H.S., Lin, C., Wu, H., Heal, M.R., 2015. Greater nitrogen dioxide concentrations at child versus adult breathing heights close to urban main road kerbside. Air Qual. Atmosphere Health, doi: 10.1007/s11869-015-0370-3.en
dc.relation.hasversionSteinle, S., Reis, S., Sabel, C.E., Semple, S., Twigg, M.M., Braban, C.F., Leeson, S.R., Heal, M.R., Harrison, D., Lin, C., Wu, H., 2015. Personal exposure monitoring of PM2.5 in indoor and outdoor microenvironments. Sci. Total Environ. 508, 383– 394.en
dc.subjectair pollutionen
dc.subjecturban air pollutant concentrationen
dc.subjectassessment methodsen
dc.subjectlow-cost portable monitorsen
dc.subjectmicroPEM monitoren
dc.subjectAeroqual monitorsen
dc.subjectultrafine particlesen
dc.subjectblack carbonen
dc.subjectemissionsen
dc.subjectmeteorological conditionsen
dc.subjecthuman exposureen
dc.subjecttraffic emissionsen
dc.subjectADMS-Urbanen
dc.subjectLand-use regression modelen
dc.subjectLUR modelen
dc.titleAssessing urban air quality through measurements and modelling and its implications for human exposure assessmenten
dc.typeThesis or Dissertationen
dc.type.qualificationlevelDoctoralen
dc.type.qualificationnamePhD Doctor of Philosophyen


Files in this item

This item appears in the following Collection(s)

Show simple item record