Consalvi, Jean L

Pizzo, Yannick

Porterie, Bernard

Torero, Jose L

IRSN and NASA

2009-01-26T09:31:55Z

2009-01-26T09:31:55Z

2007

Research journal paper published in Fire Safety Journal in 2007

Flame height is defined by the experimentalists as the average position of the luminous flame and, consequently is not directly linked with a quantitative value of a physical parameter. To determine flame heights from both numerical and theoretical results, a more quantifiable criterion is needed to define flame heights and must be in agreement with the experiments to allow comparisons. For wall flames, steady wall flame experiments revealed that flame height may be defined by a threshold value on the wall heat flux. From steady wall flame measurements, three definitions of flame height from wall heat flux are retained: the first is based on the continuous flame while the two others are based on threshold values of 4kW/m^2 and 10kW/m^2. These definitions are applied to determine flame heights from a two-dimensional time-dependent CFD model used to describe flame spread along a slab of PMMA. Results show that the predicted flame heights are consistent with the available data of the literature. Defining flame height by threshold values on the wall heat flux of 4kW/m^2 and 10kW/m^2 allows to correlate the wall heat flux in term of (x-x_p)/(x_fl-x_p), which is the dimensionless characteristic length scale for upward flame spread. It is also found that the continuous flame is not a characteristic length for the heat transfer to the unburnt fuel and is not really appropriate to define flame height in upward flame spread.

823851 bytes

application/pdf

J.L. Consalvi, Y. Pizzo, B. Porterie and J.L. Torero, On the Flame Height Definition for Upward Flame Spread, Fire Safety Journal 42 (5) pp. 384-392, 2007

http://hdl.handle.net/1842/2640

en

Elsevier

wall flame

Numerical

PMMA

On the Flame Height Definition for Upward Flame Spread

Preprint